Product Center
Product Center

RESP240-Series

RESP240-Series is based on thermosetting epoxy mixed with solder powder that shows higher reliability performance than conventional solder paste
Retail price
0.0
Market price
0.0
Number of views:
1000
Product serial number
Quantity
-
+
Stock:
0
0
Detailed introduction
Parameters

RESP240-Series is based on thermosetting epoxy mixed with solder powder that shows
higher reliability performance than conventional solder paste
Application
•   Soldering material for Flip chip and SMT in semiconductor process
•   It is applicable to pin transfer, dispensing and screen printing process
Features
•   Consistent process performance without property change in successive work
•   Excellent heat resistance at high temperature reflow
•   Excellent wetting performance and minimizing voids
•   Effect on insulation resistance due to epoxy protection
•   Effective for fine pitch due to hot slump resistance
•   Better joint strength than normal solder paste
 Less satellite ball issue after reflow
Information
Alloy : Sn3.0Ag0.5Cu
Particle Size  : T9 (1~5um), T8 (1~8um) T7 (2~11um), T6 (5~15um)
T5 (10~25um), T4 (20~38um), T3 (25~45um)
Packing size  : 200g(Jar) - customized packing available
Properties

Spec. Unit Value Measured
Color - Gray Visual
Specific gravity - 7.4 -
Thixotropic Index (TI) - 0.4~0.7 MALCOM
Viscosity @ 25 Pa.S

LV:40~80

MV:80~140

HV:140~180

MALCOM(10rpm)
Thermal Conductivity W/mK 63 Laser Flash Diffusivity
Work life Hour < 8hrs -
Shelf life Month 3month -40℃ or colder

*. Viscosity  can be adjustable per customer’s process condition

How to use
1)  Thawing
Allow container to reach room temperature before use(3 hours ago) without opening
Opening in frozen condition may cause generation of satellite balls due to condensation
Open and use after the paste reaches the room temperature(20~25℃)
2)  Mixing

Spec. RPM Sec.
Auto Mixing(Jar) 800 20~40

Manual mixing (1min ~ 2min)
Excessive mixing can make the property change

Reflow Profile

We could not find any corresponding parameters, please add them to the properties table

Learn more about products